Skip to content

A switch socket's speed and duplex set from the XGS 136's side, 2026-11-15

The XGS 136's front ports offered autoselect alone, and a change of medium was accepted and ignored. Since the change a switch socket - Port1 to Port8, copper behind the switch - offers 10 and 100 half and full, 1000baseT full and autoselect, set by the network agent's KSETTINGS attribute (0x55) with what autonegotiation advertises in attribute 0x43, as on the second XGS 3300. The cages and Port9 to Port12 keep autoselect. The request is applied by the agent's link poll, as an MTU is (npunwa_media_apply); a set already in place is not sent again, since the agent takes the port down and up for it; half duplex is read beside the speed when the carrier comes up (attribute 0x0d), and the port's address is named to the switch again at every carrier up.

The whole page, with how it was taken and what it does not show: A switch socket's speed and duplex set from the XGS 136's side, 2026-11-15.

Discussion

The discussion of this page is held in the project's GitHub Discussions. Showing it here loads giscus from giscus.app and GitHub, and writing in it needs a GitHub account - what that means.