Skip to content

Release 0.1.0-alpha.15.2

The problem reporter and verify.sh. Two owners' XGS 126s reported "they agree" - their port table confirmed - from every boot, forty times between them on issue 812, which was reopened as if a fix had failed; an agreement is now sent once from an appliance, and again only when what it confirms changes. Every report's Coprocessor software row says how the driver read that software - one of the three vendor versions it knows, or none: one of those owners' coprocessors runs vendor build 20.0.0.222, which the drivers have no row for. And verify.sh fails when the coprocessor's fast path stops answering its heartbeat, or the driver has taken the coprocessor as gone: on 2026-11-08 a lab XGS 3300's did both, and verify.sh still said nothing failed. Before the release the three lab appliances took its candidate the way an owner takes it, from 0.1.0-alpha.15.1, and their drivers carried two hours of traffic on all three without a failure; verify.sh's change, merged after that, was run on each of the three.

Improvements and additions

  • Reporter: a port check that agrees is said once; how the driver reads the coprocessor's software (#1143)
  • verify.sh: a coprocessor taken as gone, or a fast path that stopped answering its heartbeat, fails (#1144)
  • Relay: a port check that agrees is noted once for each appliance and binding, and never reopens its issue (#1142) - the problem reports' relay, deployed apart; nothing on an appliance changes with it
  • Site: the sitemaps list each page's photographs and screenshots; the home page, the news and the story pages dated by what they show (#1140, #1141) - nothing on an appliance changes with it

Documentation

  • Measurements: the check before 0.1.0-alpha.15.1, 2026-11-07 (#1138)
  • Measurements: the plugins' first signed releases, and photographs with their lines whole (#1139)

The release, with its files: v0.1.0-alpha.15.2 on GitHub.

Discussion

The discussion of this page is held in the project's GitHub Discussions. Showing it here loads giscus from giscus.app and GitHub, and writing in it needs a GitHub account - what that means.